Airtech 1069 is a high temperature FKM rubber material that is formulated to be co-cured with Airtech 1024 or Airtech 4124. The material is typically used to create a band of material around the perimeter of a silicone bag that allows the use of standard vacuum bag sealant tapes.
• Sealant tapes adhere more reliably to FKM rubber than silicone for better vacuum security.
• High temperature stability gives long service life of reusable rubber tooling.
• Easier to use than bondable release films for complex sealing strips.
| Properties listed are typical for the fully cured material | Test method |
| Material type | FKM rubber | |
| Colour | Black | |
| Hardness | 75+/-5 Shore A | ASTM D2240 |
| Density | 1,81 g/cm3 | ASTM D 792 |
| Maximum use temperature | 260°C (500°F) | |
| Elongation at break | 268 % | ASTM D412 |
| Tensile strength | 18,5 MPa | ASTM D412 die A |
| Compression set at 22 hrs. 177°C | 5 %
| ASTM D395, Method B
|
| Shelf life | 6 months when stored below 4°C |
30 days when stored at 22°C
from date of shipment when stored in original packaging
|
| Thickness | Width | Length | Packaging Type
|
|---|
| 0,51 mm (0,020 inch) | 106,7 cm (42 inch) | 22,9 m (25 yards)
| roll |
Cure Procedure:
• Airtech 1069 is a no-tack material, contact Airtech technical support for advice.
• Apply a vacuum bag and debulk 20 minutes at 0,85 bar minimum.
• Cure in an autoclave at 177°C with a minimum pressure of 3 bar for 30 minutes plus heat up time
required to bring supporting member to temperature. Maintain full vacuum throughout cure cycle 0,85 bar.
• Allow for cooling to 49°C before removal from mould.
Post Cure Instructions:
• Place fully cured material in cool oven with material exposed to air (no vacuum bag).
• Ramp temperature to 204°C in approximately half an hour.
• Post cure at 204°C for 4 hours.
• Allow for cooling at 49°C before handling.
• Shorter rolls available on special order.
• The maximum use temperature is dependent upon the duration at maximum temperature and is process
specific, Airtech recommends testing prior to use.
Last updated : 2024-07-02
As the conditions or methods of use, including storage, are beyond our control, Airtech International, Inc. does not assume responsibility for the performance of this material for any particular use. The material is sold "as is". Airtech International, Inc. disclaims, and buyer waives, any and all implied warranties, including without limitation the implied warranties of merchantability and of fitness for particular use. The information contained herein represents typical properties and should not be used for specification purposes. Any translation is provided for your convenience only. The official language is English and the official law is California, USA.
