TFG 250P bleed out fabrics are porous, PTFE coated glass fabrics which will provide release from all conventional resin systems. Porous products will allow excess resin, volatiles and trapped air to escape into the breather during cure while non-porous products will retain resin.
• Porous PTFE coating makes fabric much easier to remove off of cured laminates, resulting in time saved.
• Strips off cured laminates leaving a textured surface, reducing time spent hand finishing.
• Fibreglass retains its strength through high temperature use for easier removal after cure.
| Maximum use temperature | 260°C |
| Fibre type | PTFE Coated Fibreglass |
| Nominal thickness | 250 µm
|
| Colour | Brown |
| Shelf life | Unlimited when stored in original packaging at 22°C |
| Width | Length | Packaging |
|---|
| 1 m | 100 m | 1 roll
|
• Alternative widths available on request. MOQ may apply.
• The maximum use temperature is dependent upon the duration at maximum temperature and is process
specific, Airtech recommends testing prior to use.
• Colour is subject to slight variation. This does not affect product performance.
Last updated : 2022-11-14
As the conditions or methods of use, including storage, are beyond our control, Airtech International, Inc. does not assume responsibility for the performance of this material for any particular use. The material is sold "as is". Airtech International, Inc. disclaims, and buyer waives, any and all implied warranties, including without limitation the implied warranties of merchantability and of fitness for particular use. The information contained herein represents typical properties and should not be used for specification purposes. Any translation is provided for your convenience only. The official language is English and the official law is California, USA.
