Description

Flowrunner PP2 is a flexible resin runner for feeding resin over parts in the resin infusion process. Constructed with a ½” (1.3 cm) spiral resin line and 2” (5 cm) wide PP200 fabric, Flowrunner PP2 can be easily positioned in a vacuum bag pleat. Flowrunner leaves minimal imprint on panels and can be easily removed from cured laminates.

Benefits

• Reduce time setting up infusions with premade flow runner.
• Easier to position on shaped parts due to flexible construction.
• Removes after cure, saving time on demold.

Technical data

Material type	Polypropylene Fabric and Spiral
Colour	White
Maximum use temperature	121°C (250°F)
Shelf life	Unlimited when stored in original packaging at 22°C (72°F)

Sizes

Width	Length	Packaging
5 cm (2 inches)	50 m (54 yards)	1 roll

Notes

• The maximum use temperature is dependent upon the duration at maximum temperature and is process
specific, Airtech recommends testing prior to use.
• The gloss side of the product should go against the part surface for release after cure.
• For best results remove while the laminate is still "green" or within 24 hours.

Last updated : 2023-06-28

As the conditions or methods of use, including storage, are beyond our control, Airtech International, Inc. does not assume responsibility for the performance of this material for any particular use. The material is sold "as is". Airtech International, Inc. disclaims, and buyer waives, any and all implied warranties, including without limitation the implied warranties of merchantability and of fitness for particular use. The information contained herein represents typical properties and should not be used for specification purposes. Any translation is provided for your convenience only. The official language is English and the official law is California, USA.